b. Position left and right rack rails at the necessary 'U' position in the rack, adjusting the rails to fit the
rack, as needed. Front and Rear bottom edge of rails must align with the bottom of EIA boundary in
the lowermost 'U'.
NOTE: Rails are marked L and R with an arrow indicating the direction in which the rail is installed.
c. Use guide pins to align the shelf mount kit to the rack column holes.
d. To engage the rear rack rail mount, push the rail toward the back of the rack until the spring hook
snaps into place.
e. To engage the front rack rail mount, pull the rail towards the front of the rack to engage the spring
hook with the rack column in the same manner as the rear spring hook.
NOTE: Make sure that the respective guide pins for the square or round hole rack align properly
into rack column hole spacing.
28 HPE StoreOnce 3640 System
To Next Page
Loading...
