HPE StoreOnce 3620

12. Verify the storage enclosure cable connections.
• Two SAS cables from the storage enclosure to the first RAID controller card (slot 3)
• Two 0.5 m SAS cables between the drawers on the storage enclosure.
• Four power cables to each storage enclosure.
13. Power on the StoreOnce System (the power button is on the front of the server).
• The power button LED flashes green at the start of the power-on sequence and then turns solid
green.
• The system health LED flashes green at the start of the power-on sequence and then turns solid
green.
• If LAN port 1 is connected to an active link, the NIC status LED will also begin to flash green
when the StoreOnce System is powering up.
• While configuring the system using iLO virtual console, the UID LED flashes blue.
1
2
3
4
Item Description
1 Power LED and on/off button
2 System health LED
3 NIC status LED
4 UID LED
After successful bootup, the console displays a login prompt.
14. Configure iLO during bootup (recommended).
Most iLO settings must be configured during bootup. The iLO network options can also be configured
with the System Manager.
66 HPE StoreOnce 5250 and 5650 Systems