7 Programmed maintenance
94
HSD S.p.A. © - 0107h00a.fm100713
7.2 Biweekly maintenance
7.2.1 Tool holder cone cleaning with alcohol
For all versions:
• Carefully clean the contact surfaces of the tool holders (shown in the figure7 and 9) with a
clean and soft cloth, moistened with ethyl alcohol;
For HSK versions only
• after cleaning with ethyl alcohol, spray the tapered surface with the product KLÜBER LUSIN
PROTECT G 31 and uniformly distribute using a dry clean cloth.
• Rinse and dry the product before re-using the tool holder.
7.3 Bearings
Do not touch the bearings as they are permanently lubricated with special high
speed grease, and DO NOT NEED THE PERIODIC ADDITION OF GREASE.
To Next Page
Loading...
