9 Disposal of the product
HSD S.p.A. © - 0109h03a.fm100713
111
9 Disposal of the product
At the end of the electrospindle's life cycle, it is the user's responsibility to dispose of it in the
correct manner.
First of all, clean the various parts and then separate them into mechanical and electrical
components.
The different materials, such as electric motors (copper windings), metal components, plastic
materials, lubricants, liquid coolants, etc. must be sorted and separated then disposed of in
accordance with the laws applicable in the country of installation .
The electrospindle contains a spring that has been pre-loaded with a force of
around one hundred kilograms. This spring is applied to a screw dowel that
can be violently ejected if the electrospindle is dismantled by inadequately
trained personnel.
Only carry out the operations described in this manual. Follow the instructions
scrupulously and in the case of doubt, contact the Manufacturer's Assistance
Service..
To Next Page
Loading...
