Huawei eSpace 8950 - Wireless and Network Settings; Ethernet; Wi-Fi

27.1 Wireless and Network Settings
27.1.1 Ethernet
Step 1 Tap . On the APPLICATION tab, tap Settings.
Step 2 In the WIRELESS & NETWORKS area, tap Ethernet.
On the Ethernet settings screen, you can set the IP phone's IP address and enable the proxy
function to facilitate access to websites. For detailed operations, consult your system
administrator.
----End
27.1.2 Wi-Fi
Turning Wi-Fi on and Connecting to a Wi-Fi Network
Step 1 Tap . On the APPLICATION tab, tap Settings.
Step 2 In the WIRELESS & NETWORKS area, tap the Wi-Fi switch to turn Wi-Fi on.
The IP phone automatically scans and lists all available, in-range Wi-Fi networks.
Step 3 Select a Wi-Fi network and tap Connect.
To connect to an encrypted Wi-Fi network, you must enter the correct password.
----End
Manually Adding a Wi-Fi Network
Step 1 In the WIRELESS & NETWORKS area, tap the Wi-Fi switch to turn Wi-Fi on.
Step 2 In the Wi-Fi network list, tap
.
Step 3 Complete the required settings in the Network SSID and Security areas, and set relevant
parameters (for example, the password) following the on-screen instructions.
Step 4 Tap Save.
----End
Connecting to a Wi-Fi Network Using WPS PIN
You can use WLAN Protected Setup (WPS) to simplify connection to a Wi-Fi network. Simply
enter a PIN, and a secure Wi-Fi connection is then automatically set up. You do not need to
perform complex configurations on the management software for the Wi-Fi hotspot (for
example, a wireless router).
Step 1 In the WIRELESS & NETWORKS area, tap the Wi-Fi switch to turn Wi-Fi on.
eSpace 8950 IP Phone
User Guide
27 Settings
Issue 03 (2014-10-16) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
92