Installing Your USB Camera
Step 1 Take the camera out of the plastic bag.
Step 2 Remove the back cover of your phone and connect the camera to the USB camera port.
NOTE
Only the USB camera provided for eSpace 8950 can be connected to the USB camera port.
----End
Understanding the Camera LED
l If the camera LED is steady red, the camera is being connected. The camera LED will be
off after the camera is successfully connected and initialized.
l If the camera LED is steady blue, video is being shot.
Previewing Your Video
You can preview the video of yourself when eSpace 8950 is idle or engaged in a call.
l When the phone is idle, tap in Quick Setting to preview your video. For details about
how to add Quick Setting, see 26.1.3 Quick Setting.
l If your phone is engaged in a video call, you can also preview your video during the video
call.
NOTE
l During video preview, you can adjust the camera angle to adjust your video image. The supported
angle ranges from –25° to +15°.
l You can also adjust the brightness, contrast, and digital zoom of your camera as required. For detailed
settings, see 27.2.3 Camera.
Maintaining Your Camera
l Do not frequently remove and reseat your camera. The frequent reseat operations may cause
poor contact of the USB camera port.
l Do not use rough, unclean materials to wipe the lens. If you do so, the lens' image quality
may be affected.
l Close the shutter to protect your camera if you do not use it, or remove the camera and seal
it in a plastic bag with desiccant if the camera is not to be used for a long time.
1.2 Touchscreen Experience
NOTICE
Do not use any sharp object to touch the screen or tap the screen too hard with your fingertip;
otherwise, the touchscreen may be damaged.
Tap
Touch the object once. For example, tap to select or open an application.
eSpace 8950 IP Phone
User Guide
1 Getting Started
Issue 03 (2014-10-16) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
5
To Next Page
Loading...
