In the handset or speaker mode, tap . eSpace 8950 is then switched to the headset mode.
At the time, is displayed in the call control area.
6.3.4 Performing Video-Related Operations During a Call
During a call, you can tap
and then perform video-related operations described in Table
6-2.
Table 6-2 Video-related operations
If You Want to... Then...
Switch an audio call to a
video call
Tap Video Call. After your peer accepts your video call request,
you can see each other's video.
Switch a video call to an
audio call
Tap Audio Call. Then, the video call screen is closed, and the
audio call screen is displayed.
Stop video Tap Stop Video. Your IP phone stops your local camera, and your
peer can no longer view your video.
Start video Tap Start Video. Your IP phone starts your local camera, and
your peer can view your video.
Switch between the
small and large video
panes
Tap Switch. Then, the two video panes on the screen are switched.
Disable self-video (local
video preview)
Tap Close Self-Video. Then, your local video is stopped.
Enable self-video (local
video preview)
Tap Show Self-Video. Then, your local video is started.
Move the small video
pane
Drag the small video pane to the desired location.
6.3.5 Two-Stage Dialing
Two-stage dialing is usually used in interactive voice response (IVR). For example, when you
call a customer service center, you can hear the system announcements. Then, you dial a number
as prompted.
Step 1 During a call, tap
.
Step 2 On the two-stage dialing screen, enter digits as prompted.
----End
6.3.6 Initiating Another Call While on a Call
eSpace 8950 IP Phone
User Guide
6 Call
Issue 03 (2014-10-16) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
31
To Next Page
Loading...
