Huawei FusionDC1000A - Product Configuration

● You can learn the peak power consumption of the data center, which provides
data support for improving the lease rate and usage of electricity.
● You can collect statistics on cabinet usage, providing support for improving
the lease rate and usage of cabinets.
NO TE
The management system of the FusionDC1000 is congured by using the iManager NetEco
congurator.
Figure 6-2 Layout of management system components
(1) Camera (monitors the long
aisle)
(2) Rack-A1 cabinet (3) Smart ETH gateway
(4) FusionModule Actuator (5) Camera (monitors the
entrance room and main
entrance)
(6) PAD
(7) Water sensor
NO TE
The ECC800-Pro is deployed in the Rack-A1 cabinet.
6.2 ECC800-Pro
6.2.1 Product Conguration
The ECC800-Pro data center controller is mainly used to monitor the devices and
environment in a data center. It consists of the power supply units (PSUs) and
main control module, which are pluggable.
You can congure the ECC800-Pro collector in the following two manners:
Conguration 1 (typical conguration): one PSU and one main control module
Conguration 2: two PSUs and one main control module.
FusionDC1000A Prefabricated All-in-One Data
Center
Product Description (IT Scenario) 6 Management System
Issue 04 (2023-11-10) Copyright © Huawei Digital Power Technologies Co., Ltd. 66