Huawei FusionDC1000A - Page 83

Indica
tor
Color Name Status Description
Blinking at
long
intervals
The software runs properly
(the indicator blinks at 0.5
Hz, on for 1s and then o
for 1s) or the ECC800-Pro
registers with the
management system
successfully.
Blinking at
short
intervals
The ECC800-Pro does not
register with the
management system (the
indicator blinks at 5 Hz, on
for 0.1s and then o for
0.1s).
ALM Red Alarm indicator Steady on A system failure alarm is
generated.
O The system is normal.
RF_Z Green Communication
status indicator
Blinking at
long
intervals
A network is set up, and no
node access is allowed (the
indicator blinks at 0.5 Hz, on
for 1s and then o for 1s).
Blinking at
super
short
intervals
A network is set up, and
node access is allowed (the
indicator blinks at 10 Hz, on
for 0.05s and then o for
0.05s).
SW Button
Table 6-15 SW button description
Function
Description
Operation Description Indicator Status
Wireless
network RF_Z
(802.15.4)
pairing
In non-wireless network (802.15.4)
pairing mode, hold down the button
for 3s to 5s to enter the wireless
network pairing mode.
The RF_Z indicator is
blinking at super
short intervals.
In wireless network (802.15.4)
pairing mode, hold down the button
for 3s to 5s to exit the pairing mode;
or the system automatically exits the
pairing mode after 30 minutes.
The RF_Z indicator is
blinking at long
intervals.
FusionDC1000A Prefabricated All-in-One Data
Center
Product Description (IT Scenario) 6 Management System
Issue 04 (2023-11-10) Copyright © Huawei Digital Power Technologies Co., Ltd. 76