Huawei FusionServer Pro 2288H V5 - Enabling VMD; Disabling VMD

l The VMD function must be enabled on the BIOS in UEFI mode only. The BIOS in
legacy mode does not support this setting.
l Use Intelligent Computing Compatibility Checker to obtain information about the
operating systems supported by the VMD function.
l If the VMD function is enabled and the latest VMD driver is installed, the NVMe drives
support surprise hot swap.
9.5.1 Enabling VMD
Procedure
Step 1 Access the BIOS interface.
Step 2 Choose Advanced.
Step 3 Select Socket Configuration and press Enter.
Step 4 Select IIO Configuration and press Enter.
Step 5 Select Intel(R) VMD Technology and press Enter.
Step 6 Select Intel(R) VMD Config and press Enter.
Step 7 Select Auto and press Enter.
Step 8 Press F10.
The Save Changes&Exit dialog box is displayed.
Step 9 Select Yes and press Enter.
The server automatically restarts for the settings to take effect.
----End
9.5.2 Disabling VMD
Procedure
Step 1 Access the BIOS interface.
Step 2 Choose Advanced.
Step 3 Select Socket Configuration and press Enter.
Step 4 Select IIO Configuration and press Enter.
Step 5 Select Intel(R) VMD Technology and press Enter.
Step 6 Select Intel(R) VMD Config and press Enter.
Step 7 Select Disabled and press Enter.
Step 8 Press F10.
The Save Changes&Exit dialog box is displayed.
Step 9 Select Yes and press Enter.
FusionServer Pro 2288H V5 Server
User Guide
9 Common Operations
Issue 08 (2019-10-30) Copyright © Huawei Technologies Co., Ltd. 135