7.2.6.2 Connecting Mouse, Keyboard, and VGA Cables
The front and rear panels of the server provide DB15 VGA ports but no standard PS/2 port for
a keyboard or mouse.
You can connect a keyboard and mouse to the USB port on the front or rear panel based on
site installation conditions. There are two connection methods:
l Connect the keyboard and mouse to the USB ports.
l Connect the keyboard and mouse using a USB-to-PS/2 cable.
This section describes how to connect a keyboard and mouse using a USB-to-PS/2 cable and
connect a monitor using a VGA cable.
Procedure
Step 1 Connect the USB connector of the USB-to-PS/2 cable to a USB port on the front or rear panel
of the server.
Step 2 Connect the PS/2 connectors of the USB-to-PS/2 cable to the keyboard and mouse.
Step 3 Connect the DB15 connector of the VGA cable to the VGA port on the front or rear panel of
the server and tighten the two screws.
Step 4 Connect the other connector of the VGA cable to the VGA port on the monitor and tighten the
two screws.
Figure 7-14 Connecting a USB-to-PS/2 cable and VGA cable
----End
7.2.6.3 Connecting Network Cables
Before connecting or replacing a network cable, use a network cable tester to ensure that the
new network cable is functional.
Procedure
Step 1 Determine the model of the new network cable.
l Shielded cables are recommended.
FusionServer Pro 2288H V5 Server
User Guide
7 Installation and Configuration
Issue 08 (2019-10-30) Copyright © Huawei Technologies Co., Ltd. 87
To Next Page
Loading...
