Huawei FusionServer Pro 2288H V5 - 2.5 Storage

Port Type Quantity Description
GE electrical
port
1000BASE-T 2 GE LOM service ports (electrical).
VGA port DB15 1 Used to connect a display
terminal, such as a monitor or
keyboard video mouse console
(KVM).
Serial port RJ45 1 The port uses 3-wire serial
communication interface, and the
default baud rate is 115,200 bit/s.
Default system serial port used for
debugging. You can also set the
iBMC serial port as the system
debug port by using the iBMC
command.
Management
network port
1000BASE-T 1 Used for server management.
NOTE
The management network port is a
GE port that supports 100 Mbit/s and
1000 Mbit/s auto-negotiation.
USB port USB 3.0 2 Used to connect to a USB device.
NOTICE
Before connecting an external USB
device, check that the USB device
functions properly. The server may
operate abnormally if an abnormal
USB device is connected.
PSU socket - 2 Used to connect to the power
distribution unit (PDU) in the
cabinet. You can select the number
of power supply units (PSUs) as
required.
NOTE
l When determining the quantity of
PSUs, ensure that the rated power
of the PSUs is greater than that of
the server.
l If only one PSU is used,
Predicted PSU Status cannot be
set to Active/Standby on the
iBMC WebUI.
FusionServer Pro 2288H V5 Server
User Guide
2 Hardware Description
Issue 08 (2019-10-30) Copyright © Huawei Technologies Co., Ltd. 18