(3) Click OK. In the dialog box that is displayed, click OK. After the device
automatically restarts, the configuration takes effect.
----End
Result
Check whether the telephone functions properly. Connect two common telephones phone 1 and
phone 2 to two TEL ports on the ONT and test the dialing between phone 1 and phone 2. In
normal cases:
l The caller hears the dialing tone after taking the phone off the hook.
l When the caller dials the telephone number of the callee, the phone of the callee rings
successfully, and the caller hears the ring back tone.
l The caller and the callee communicate with each other successfully.
l After the callee hangs up, the caller hears the busy tone.
3.2.6 Configuring GPON FTTH Layer 2 Multicast Service on the
NMS
This topic describes how to configure the multicast service when an ONT is connected to an
OLT through a GPON port.
Context
For details of the data plan, see Data Plan.
Example Network
l The ONT is connected to the OLT in Layer 2 mode.
l The OLT uses IGMP proxy, which is a Layer 2 multicast protocol.
l The IGMP version of the multicast VLAN is IGMPv3.
l Multicast programs are configured statically.
EchoLife HG8240/HG8245/HG8247 GPON Terminal
Service Manual 3 Configuration
Issue 04 (2011-01-12) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
3-67
To Next Page
Loading...
