3.3.7 Configuring the GPON FTTH Layer 3 Bridge Multicast Service
on the OLT CLI
The OLT is connected to the remote ONT through a GPON port to provide users with the IPTV
service.
Service Requirements
l The ONT is connected to the OLT in the Layer 3 bridge mode.
l The OLT adopts IGMP proxy, a Layer 2 multicast protocol.
l Multicast programs are configured statically and multicast users are authenticated.
l The IGMP version of the multicast VLAN is IGMP V3.
l The user accesses the device through GPON, and has the right to order programs from the
multicast source.
Table 3-10 Data plan
Item Data
OLT Service VLAN ID: 1000
Service VLAN type: smart VLAN
Upstream port: 0/19/0
Multicast protocol: IGMP Proxy
Multicast version: IGMP V3
Multicast forwarding packets: untag
IP address of the multicast server: 10.10.10.10
Multicast program: 224.1.1.10
ONT ONT IDs: 1 and 2
ID of the port on the ONT that is connected to the STB: 3
Type of the port on the ONT that is connected to the STB:
ETH
VLAN ID of the port on the ONT that is connected to the
STB: 30
Prerequisite
l The license for the multicast program or the multicast user must already be requested and
installed.
l The OLT is connected to the BRAS and the multicast source.
l The VLAN of the LAN switch port connected to the OLT is the same as the upstream
VLAN of the OLT.
Procedure
l Configure the OLT.
EchoLife HG8240/HG8245/HG8247 GPON Terminal
Service Manual 3 Configuration
Issue 04 (2011-01-12) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
3-159
To Next Page
Loading...
