Huawei HG8240 - Wi-Fi Advanced Configuration

Parameter Description
Encryption Mode Indicates the encryption mode for the STA to request access to
the wireless network. The encryption mode and encryption
parameters vary with the authentication mode.
l If the authentication mode is set to Open, the encryption
mode can be set to None or WEP.
l If the authentication mode is set to Shared, the encryption is
WEP.
l If the authentication mode is set to WPA Pre-Shared Key,
WPA2 Pre-Shared Key, WPA Enterprise, or WPA2
Enterprise, the encryption mode can be set to AES, TKIP,
or TKIP&AES.
l If the authentication mode is set to Wi-Fi Protected Setup,
WPS Mode must be set to Pin or Push-button.
NOTE
l Pin indicates the pin-based encryption.
l Push-button indicates the push-button-based encryption.
When WPS Mode is set to Push-button, press the WPS button on
the ONT and press the WPS icon included with the STA within two
minutes, or run the WPS setup program in the STA to install the WPS
software.
NOTE
l The security mode and encryption configured on a Wi-Fi terminal must be the same as those of an ONT. If
the TKIP&AES, or AES encryption mode is not configured on the Wi-Fi terminal, the Wi-Fi terminal may
have an old-version driver. If so, update the driver version.
l When two SSIDs are configured, if you modify the information of an SSID, the other SSID will re-choose
a channel, causing the service to be interrupted for a few minutes.
5.4.2 Wi-Fi Advanced Configuration
1. In the navigation tree on the left, choose WI-FI > Wi-Fi Advanced Configuration. In the
pane on the right, set the advanced Wi-Fi parameters, including the transmit power,
regulatory domain, and channel, as shown in Figure 5-16.
EchoLife HG8240/HG8245/HG8247 GPON Terminal
Service Manual 5 Web Page Reference
Issue 04 (2011-01-12) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
5-17