on the ONT, the ONT is connected to the upper-layer device in GPON mode to implement
high-speed Internet access service.
l The high-speed Internet access service is identified by two precisely-bound VLAN tags.
On the ONT, each user is allocated with a CVLAN; on the OLT, each slot is allocated with
an SVLAN.
l The high-speed Internet access service adopts a bandwidth-ensured mode with the
maximum bandwidth 100 Mbit/s as the DBA profile and performs the 4 Mbit/s rate
limitation on both the upstream and downstream directions.
Table 3-6 Data Plan
Item Data
OLT Service VLAN ID: 100
Service VLAN type: Smart
Upstream port: 0/19/0
ONT ONT IDs: 1 and 2
ID of the port on the ONT that is connected to the PC: 1
Type of the port on the ONT that is connected to the PC:
ETH
VLAN ID of the port on the ONT that is connected to the
PC: 10
User name for PPPoE dialup: iadtest@pppoe; password:
iadtest
Prerequisite
l The OLT is connected to the BRAS.
l Related configurations are performed on the BRAS according to the authentication and
accounting requirements for dialup users. For details about the configuration, see the
corresponding configuration guide.
l The VLAN of the LAN switch port connected to the OLT is the same as the upstream
VLAN of the OLT.
Procedure
l Configure the OLT.
1. Create a service VLAN and add an upstream port to it.
The VLAN ID is 100, and the VLAN is a smart VLAN. Add upstream port 0/19/0 to
VLAN 100.
huawei(config)#vlan 100 smart
huawei(config)#port vlan 100 0/19 0
2. (Optional) Configure upstream link aggregation.
In this example, a single upstream port is used. In the case of multiple upstream ports,
upstream link aggregation can be configured. For details, see Configuring Upstream
Link Aggregation.
3. Configure GPON ONT profiles.
3 Configuration
EchoLife HG8240/HG8245/HG8247 GPON Terminal
Service Manual
3-110 Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Issue 04 (2011-01-12)
To Next Page
Loading...
