Figure 6-6 Installing the pRRU housing
NOTE
The Phillips screw is the one removed and kept in Step 4.
Step 9 Power on the pRRU.
Step 10 Instruct the network operator to unblock the pRRU.
l On the UMTS side, log in to the NodeB LMT and run the UBL BRD command to unblock
the RF daughter board of the pRRU.
l On the LTE side, log in to the eNodeB LMT and run the UBL BRD command to unblock
the RF daughter board of the pRRU.
Step 11 Take off the ESD gloves and pack up all the tools.
----End
LampSite
Installation Guide 6 Appendix
Issue 02 (2014-05-27) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
95
To Previous Page
Loading...
