Huawei LampSite - 4.3.3 Installing an RHUB on a Wall

Figure 4-21 Tightening screws
----End
4.3.3 Installing an RHUB on a Wall
An RHUB can be installed on a wall.
Procedure
Step 1 The mounting ears are installed in reverse mode by default. Before installing an RHUB on a
wall, modify the installation mode of the mounting ears on the RHUB.
l Use a torque screwdriver or Phillips screwdriver to remove the mounting ears on both sides
of the RHUB by removing the four M4×8 screws, as shown in Figure 4-22.
LampSite
Installation Guide
4 Installing an RHUB
Issue 02 (2014-05-27) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
24