Huawei LampSite - Prru Installed on a Ceiling

NOTE
If the screws cannot be tightened using a Phillips screwdriver, use a hex key or an electric screwdriver to
assist the installation.
Step 5 Fit the four hooks of the pRRU into the installation kits, as shown in Figure 5-11. If the hooks
are properly installed, a slight clack can be heard.
NOTE
It is recommended that you observe the installation from one side of the pRRU when inserting hooks into
the kits.
Figure 5-11 Installing the pRRU on a plate
----End
5.4.3 pRRU Installed on a Ceiling
This section describes the procedure of installing a pRRU on the ceiling, such as the concrete
ceiling, when the ceiling has sufficient load bearing capacity and installation space.
LampSite
Installation Guide
5 Installing a pRRU
Issue 02 (2014-05-27) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
60