Step 5 Fit the four hooks of the pRRU into the installation kits, as shown in Figure 5-15. If the hooks
are properly installed, a slight clack can be heard.
NOTE
It is recommended that you observe the installation from one side of the pRRU when inserting hooks into
the kits.
Figure 5-15 Installing a pRRU
----End
5.4.4 pRRU Installed on a Pole
A pRRU can be installed on a metal pole indoors.
Procedure
Step 1 Determine the position for installing the pRRU based on the construction blueprint and the space
requirements.
NOTE
For pRRU installation space requirements, see 5.1.3 Space Requirements.
Step 2 If the diameter of the pole ranges from 30 mm to 70 mm, use the delivered V clamp, installation
plate, and bolts to install the pRRU on the pole. Lead the M6x80 bolt through the plate, and
tighten the bolt to a torque of 5 N•m, as shown in Figure 5-16.
LampSite
Installation Guide
5 Installing a pRRU
Issue 02 (2014-05-27) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
63
To Next Page
Loading...
