Figure 5-7 Plate specifications
5.4.2 pRRU Installed on a Wall
If the wall indoors has sufficient load bearing capacity and space, the pRRU is recommended
to install on a wall. If the wall cannot bear the capacity, choose an installation mode based on
site requirements.
Context
NOTICE
This section only describes the procedure of installing the pRRU on a wall without any other
auxiliary devices. The installation procedure of other wall-mounted modes is similar to that of
installing the pRRU on a wall without auxiliary devices.
Procedure
Step 1 Determine the position for installing the pRRU based on the construction blueprint and the space
requirements.
NOTE
For pRRU installation space requirements, see 5.1.3 Space Requirements.
Step 2 Place the plate in the installation position against the wall. Then, level the plate and mark the
two anchor points using a marker, as shown in Figure 5-8.
LampSite
Installation Guide
5 Installing a pRRU
Issue 02 (2014-05-27) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
57
To Next Page
Loading...
