Step 3 Fit the four hooks of the pRRU into the installation kits, as shown in Figure 5-18. If the hooks
are properly installed, a slight clack can be heard.
NOTE
It is recommended that you observe the installation from one side of the pRRU when inserting hooks into
the kits.
Figure 5-18 Installing a pRRU
----End
5.4.5 pRRU Installed on a Plate
If the plate on the ceiling has sufficient load bearing capacity and space installation, the pRRU
can be installed on the plate of the ceiling indoors.
Procedure
Step 1 Determine the position for installing the pRRU based on the construction blueprint and the space
requirements.
NOTE
For pRRU installation space requirements, see 5.1.3 Space Requirements.
Step 2 Place the plate in the installation position against the wall. Then, level the plate and mark the
two anchor points using a marker, as shown in Figure 5-19.
LampSite
Installation Guide
5 Installing a pRRU
Issue 02 (2014-05-27) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
65
To Next Page
Loading...
