Figure 4-22 Removing screws and mounting ears
l Rotate the mounting ears 90 degrees clockwise, and use a torque screwdriver or Phillips
screwdriver to secure the mounting ear with a torque of 1.4 N•m, as shown in Figure 4-23.
Figure 4-23 Installing mounting ears and screws
Step 2 Determine the position on the wall for installing the RHUB based on the requirements in the
engineering blueprint and 4.1.2 Installation Clearance Requirements of an RHUB. Place the
RHUB to the position to be installed against the wall, and then mark the four anchor points where
the mounting ear screws are fastened using a marker, as shown in Figure 4-24.
LampSite
Installation Guide
4 Installing an RHUB
Issue 02 (2014-05-27) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
25
To Next Page
Loading...
