Figure 4-12 Manual handling
Figure 4-13 Hoisting
Step 3 Check whether there is a gap between the base support and the concrete
platforms. If yes, level the base support using leveling spacers delivered with the
product.
Step 4 Secure the base support to the foundation.
● You are advised to place the base support with its DC side facing the ESS.
● The base support requires six mounting holes on the foundation. Mark all the
mounting holes.
Each angle steel bracket must be secured at one mounting hole. If the drill bit interferes
with reinforcing steel bars in the concrete foundation or the position of the rst drilled hole
is deviated, use a spare mounting hole.
LUNA2000-213KTL-H0 Smart Power Control System
User Manual 4 Installation
Issue 04 (2024-12-30) Copyright © Huawei Technologies Co., Ltd. 40
To Next Page
Loading...