Installation Manual
Quidway S3900 Series Ethernet Switches Chapter 4 Starting up the Switch at the Initial Boot
Huawei Technologies Proprietary
4-7
Mac Address : 0x00e0fc003900
Press Ctrl-B to enter Boot Menu... 5
To enter the Boot Menu, press <Ctrl+B> within five seconds after the message “Press
Ctrl-B to enter Boot Menu... 5” appears. If not, the system automatically boots and
displays:
Auto-booting...
Decompress
Image..............................................................
...................................................................
...................................................................
...................................................................
...................................................................
...............................................OK!
Starting at 0x80100000...
Initialize LSJ1LTSE........................OK!
SDRAM fast selftest........................OK!
Flash fast selftest........................OK!
CPLD selftest..............................OK!
Switch chip selftest.......................OK!
PHY selftest...............................OK!
Please check port leds...............FINISHED!
User interface aux0 is available.
Press ENTER to get started.
The appearance of “Press ENTER to get started” indicates that the switch has
completed its automatic boot.
Press <Enter>; the system displays:
<Quidway>
You can configure the switch now.
To Next Page
Loading...
