policy-vlan mac-address mac-address ip ip-address [ interface interface-type
interface-number ] [ priority priority ]
Policy VLAN is configured.
If interface interface-type interface-number is not specified, the MAC and IP address policy
will be applied to all ports in the VLAN. If interface interface-type interface-number is
specified, the MAC and IP address policy will be applied to the specified port in the VLAN.
Before deleting a policy VLAN, run the undo policy-vlan command to disable the policy VLAN
function.
Step 4 Run:
quit
The system view is displayed.
Step 5 Configure the port type and features.
1. Run the interface interface-type interface-number command to enter the view of the port
to be configured with a policy VLAN.
2. Run the port link-type hybrid command to set the port type to hybrid.
By default, the port type is hybrid.
3. Run the port hybrid untagged vlan { { vlan-id1 [ to vlan-id2 ] } &<1-10> | all } command
to allow frames with specified MAC and IP addresses to pass through.
----End
3.3.7 Checking the Configuration
After dividing a LAN into VLANs, you can view information about VLANs configured in
different modes. For example, which VLANs are classified based on ports or MAC addresses.
Prerequisite
The configurations of VLAN division are complete.
Procedure
l Run the display vlan [ vlan-id [ verbose ] ] command to check information about all
VLANs or a specified VLAN.
l Run the display mac-vlan { mac-address { all | mac-address } | vlan vlan-id } command
to check information about VLANs configured based on MAC addresses.
l Run the display ip-subnet-vlan vlan { all | vlan-id1 [ to vlan-id2 ] } command to check
information about VLANs configured based on IP subnets.
l Run the display protocol-vlan vlan { all | vlan-id1 [ to vlan-id2 ] } command to check
information about VLANs configured based on protocols.
l Run the display protocol-vlan interface { all | interface-type interface-number } command
to check information about VLANs configured based on protocols associated with ports.
l Run the display policy-vlan { all | vlan vlan-id } command to check information about
policy vlan.
----End
Quidway S7700 Smart Routing Switch
Configuration Guide - Ethernet 3 VLAN Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
86
To Next Page
Loading...
Need help?
General
