Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface interface-type interface-number
The view of an Ethernet interface added to the SEP segment is displayed.
Step 3 Run:
stp disable
STP is disabled on the interface.
Step 4 Run:
sep segment segment-id [ edge [ no-neighbor ] { primary | secondary } ]
The Ethernet interface is added to a specified SEP segment and a role is configured for it.
NOTE
An interface can be added to only two SEP segments.
----End
10.2.6 Checking the Configuration
After basic SEP functions are configured, you can view the information such as the names and
roles of interfaces added to an SEP segment, status of the interfaces on neighbors, and forwarding
status of the local interface.
Prerequisite
The configurations of basic SEP functions are complete.
Procedure
l Run the display sep interface [ interface-type interface-number | segment segment-id ]
[ verbose ] command to check the information about interfaces that reside on the device
and are added to a specified SEP segment.
l Run the display sep topology [ segment segment-id ] [ verbose ] command to check the
topology status of a specified SEP segment.
----End
10.3 Specifying an Interface to Block
By default, the blocked interface is one of the last two interfaces that complete neighbor
negotiation. Sometimes, the negotiated blocked interface, however, may not be the expected
one. An interface can be selected to block as required.
Quidway S7700 Smart Routing Switch
Configuration Guide - Ethernet 10 SEP Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
511
To Next Page
Loading...
Need help?
General
