No. Data
6 Control VLAN ID, and type and number of each sub-interface
NOTE
You can perform any of the following configurations on a sub-interface as required.
5.9.2 Configuring a Dot1q Sub-interface
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface interface-type interface-number.subinterface-number
The view of the PE sub-interface connected to the CE is displayed.
Step 3 Run:
control-vid vid dot1q-termination
The control VLAN ID and encapsulation mode of the sub-interface are set.
Step 4 Run:
dot1q termination vid low-pe-vid [ to high-pe-vid ]
The VLANs whose packets are allowed to pass through the dot1q sub-interface are specified.
----End
5.9.3 Configuring a QinQ Sub-interface
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface interface-type interface-number.subinterface-number
The view of the PE sub-interface connected to the CE is displayed.
Step 3 Run:
control-vid vid qinq-termination
The control VLAN ID and encapsulation mode of the sub-interface are set.
Step 4 Run:
qinq termination pe-vid pe-vid ce-vid ce-vid1 [ to ce-vid2 ]
Quidway S7700 Smart Routing Switch
Configuration Guide - Ethernet 5 QinQ Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
206
To Next Page
Loading...
Need help?
General
