Step 2 Run:
interface pos interface-number
The POS interface view is displayed.
Step 3 Run:
flag c2 c2–value
flag j0 { 1byte-mode value | 16byte-mode value | 64byte-or-null-mode value | peer }
flag j1 { 1byte-mode value | 16byte-mode value | 64byte-or-null-mode value | peer }
Overhead bytes of the POS interface are configured.
----End
1.3.5 Configuring Frame Format
The frame format of an interface determines the application mode of the interface. POS interfaces
support two frame formats, namely, SDH and SONET.
Context
A POS interface supports the following types of frame formats:
l SDH
l SONET
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface pos interface-number
The POS interface view is displayed.
Step 3 Run:
frame-format { sdh | sonet }
Frame format of the POS interface is configured.
By default, the frame format of a POS interface is SDH.
----End
1.3.6 Configuring the Scramble Function
POS interfaces support the scrambling function for the payload data to avoid excessive number
of consecutive 1s or 0s and help the receiver extract line clock signals.
Context
The scrambling function of the directly connected interfaces must be configured the same.
Quidway S9300 Terabit Routing Switch
Configuration Guide - WAN Access 1 POS Interface Configuration
Issue 02 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
8
To Next Page
Loading...
Need help?
General
