EasyManua.ls Logo

Huawei Quidway S9300

Huawei Quidway S9300
60 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
The link layer protocol of the interfaces that are added into an IP-Trunk interface
must be HDLC.
By default, the link layer protocol of a POS interface is PPP. You need to run the
link-protocol hdlc command in the POS interface view to change the link layer
protocol to HDLC.
Before adding an interface to an IP-Trunk, ensure the interface is not configured
with any Layer 3 feature or service.
A POS interface can join only one IP-Trunk interface. To add the POS interface
to another IP-Trunk interface, you must remove it from the original IP-Trunk first.
Member interfaces of an IP-Trunk cannot be IP-Trunks.
The POS interfaces of different interface boards can be added into the same IP-
Trunk.
Do not bind interfaces with different forwarding capabilities to an IP-Trunk.
After interfaces with different forwarding capabilities are bound to an IP-Trunk,
each interface assumes the least capability among all the interfaces. For example,
after a 10 Gbit/s POS interface and a 2.5 Gbit/s POS interface are added into an
IP-Trunk, the transmission capability of the 10 Gbit/s POS interface can only reach
2.5 Gbit/s. The transmission capability of the IP-Trunk is 5 Gbit/s rather than 12.5
Gbit/s.
If an IP-Trunk is created on a local device, the peer device interfaces that are
directly connected with the member interfaces must be bound to an IP-Trunk
interface. Otherwise, the two ends cannot communicate.
----End
3.4.3 Configuring an IP Address for the IP-Trunk Interface
You can assign an IP address to an IP-Trunk interface and configure member interfaces to borrow
the IP address of the IP-Trunk interface.
Context
Do as follows on the switchs that are configured with IP-Trunk interfaces.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface ip-trunk trunk-id
The IP-Trunk interface view is displayed.
Step 3 Run:
ip address ip-address { mask | mask-length }
The IP address is configured for the IP-Trunk interface.
----End
Quidway S9300 Terabit Routing Switch
Configuration Guide - WAN Access 3 HDLC and IP-Trunk Configuration
Issue 02 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
45

Table of Contents

Other manuals for Huawei Quidway S9300

Related product manuals