Huawei Quidway S9300

Last 600 seconds input rate 65184 bits/sec, 36 packets/sec
Last 600 seconds output rate 8 bits/sec, 0 packets/sec
Input peak rate 4380776 bits/sec,Record time: 2011-01-11 17:34:39
Output peak rate 1760 bits/sec,Record time: 2011-01-11 17:04:32
Input: 11256 packets, 2484257 bytes
Input error: 185 shortpacket, 0 longpacket, 10618 CRC, 5 lostpacket
Output: 211 packets, 9748 bytes
Output error: 0 lostpacket
Input bandwidth utilization : 0.04%
Output bandwidth utilization : 0.01%
----End
Configuration Files
l Configuration file of Switch A
#
sysname SwitchA
#
interface Pos 1/0/0
ppp authentication-mode pap
ip address 10.110.0.1 255.255.255.0
#
aaa
local-user rtb password simple quidway
#
return
l Configuration file of Switch B
#
sysname SwitchB
#
interface Pos1/0/0
link-protocol ppp
ppp pap local-user rtb password simple quidway
ip address 10.110.0.2 255.255.255.0
#
return
2.6.2 Example for Configuring Unidirectional CHAP
Authentication
This example shows how to configure two devices so that one end (the authenticator) can
authenticate the other end (the authenticated) in CHAP mode in typical networking.
Networking Requirements
As shown in Figure 2-2, Switch A is required to authenticate Switch B in CHAP mode and
should be configured with a user name.
Figure 2-2 Networking diagram of unidirectional CHAP authentication
POS1/0/0
10.110.0.1/24
POS1/0/0
10.110.0.2/24
Switch A
Switch B
Quidway S9300 Terabit Routing Switch
Configuration Guide - WAN Access 2 PPP Configuration
Issue 02 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
32