Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface pos interface-number
The POS interface view is displayed.
Step 3 Run:
scramble
The scrambling function of the payload is configured for the POS interface.
By default, the scrambling function is enabled on the payload.
----End
1.3.7 Configuring the Length of the CRC Check Character
POS interfaces support the CRC character in either 16 bits or 32 bits.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface pos interface-number
The POS interface view is displayed.
Step 3 Run:
crc { 16 | 32}
The length of the CRC check character is configured for the POS interface.
By default, 32-bit CRC is adopted.
----End
1.3.8 Configuring MTU
The MTU is used to assemble and disassemble packets on a POS interface when packets are
sent and received on the interface through the IP network protocol.
Context
A switch reassembles and fragments the sent and received packets according to the MTU.
Quidway S9300 Terabit Routing Switch
Configuration Guide - WAN Access 1 POS Interface Configuration
Issue 02 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
9
To Next Page
Loading...
Need help?
General
