Applicable Environment
PPP is a link layer protocol that is used to transmit data over P2P links. If MTUs are configured
on the two ends of a link, enable PPP MTU negotiation on the two ends to negotiate the MTU
for data exchange. The MTUs on the two ends must be identical.
Pre-configuration Tasks
Before configuring the PPP protocol, complete the following task:
l Connecting interfaces and setting physical parameters of the interfaces so that the physical
layer of the interfaces goes Up
Data Preparation
To configure the PPP protocol, you need the following data.
No. Data
1 Number of the interface
2 PPP negotiation timeout
3 Polling interval
2.3.2 Encapsulating the Interface with PPP
This section describes how to configure PPP as the link layer protocol on an interface.
Context
Do as follows on the switch.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface interface-type interface-number
The interface view is displayed.
Step 3 Run:
link-protocol ppp
The link layer protocol is configured as PPP.
By default, the link layer protocol of the POS interface is PPP.
----End
Quidway S9300 Terabit Routing Switch
Configuration Guide - WAN Access 2 PPP Configuration
Issue 02 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
18
To Next Page
Loading...
Need help?
General
