2.3.3 Configuring the Timeout Period of Negotiation
During PPP negotiation, if the peer does not reply with a response packet before the negotiation
times out, PPP resends the negotiation request packet.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface interface-type interface-number
The interface view is displayed.
Step 3 Run:
ppp timer negotiate seconds
The timeout period of negotiation is configured on the interface.
By default, the PPP negotiation timeout time is 3 seconds.
----End
2.3.4 Configuring the Polling Interval
This section describes how to configure the interval for sending Keepalive packets to the peer.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface interface-type interface-number
The interface view is displayed.
Step 3 Run:
timer hold seconds
The polling interval is configured on the interface.
By default, the interval for sending Keepalive messages on a POS interface is 10 seconds.
----End
2.3.5 Preventing the Peer Host Route from Being Added to the Local
Routing Table of Direct Routes
This section describes how to prevent the peer host route from being added to the local routing
table of direct routes. This prevents the situation that one end is configured with an incorrect IP
address, and the other end automatically adds the incorrect peer host route to the local routing
table, which results in advertisement of incorrect routing information on the network.
Quidway S9300 Terabit Routing Switch
Configuration Guide - WAN Access 2 PPP Configuration
Issue 02 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
19
To Next Page
Loading...
Need help?
General
