Huawei Quidway S9300

NOTE
After changing the username and password, run the restart command, or the shutdown and
undo shutdown commands in the interface view to validate the configuration.
l Configuring the authenticated
1. Run:
system-view
The system view is displayed.
2. Run:
aaa
The AAA view is displayed.
3. Run:
local-user user-name password { simple | cipher } password
The username and password of the authenticated are added to the local user list.
4. Run:
quit
Return to the system view.
5. Run:
interface interface-type interface-number
The interface view is displayed.
6. Run:
ppp chap user user-name
The local username is configured.
7. Run:
restart
The interface is restarted.
NOTE
After changing the username and password, run the restart command, or the shutdown and
undo shutdown commands in the interface view to validate the configuration.
----End
2.5.3 Configuring a Local Device Without a User Name to
Authenticate Its Peer in CHAP Mode
This section describes how to configure the authenticator without a user name to authenticate
the peer in CHAP mode.
Procedure
l Configuring the authenticator
1. Run:
system-view
The system view is displayed.
2. Run:
Quidway S9300 Terabit Routing Switch
Configuration Guide - WAN Access 2 PPP Configuration
Issue 02 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
27