Return to the system view.
Step 5 Run:
interface interface-type interface-number
The interface view is displayed.
Step 6 Run:
ppp authentication-mode pap
The local end authenticates the peer end using PAP.
Step 7 Run:
restart
The interface is restarted.
NOTE
After changing the username and password, run the restart command, or the shutdown and undo
shutdown commands in the interface view to validate the configuration.
----End
2.4.3 Configuring the Peer to Be Authenticated by the Local Device
in PAP Mode
This section describes how to configure PAP-related attributes for the authenticated user.
Context
Do as follows on the switch.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface interface-type interface-number
The interface view is displayed.
Step 3 Run:
ppp pap local-user user-name password { cipher | simple } password
The username and password of the local end are configured when the local end is configured to
be authenticated using PAP.
Step 4 Run:
restart
The interface is restarted.
Quidway S9300 Terabit Routing Switch
Configuration Guide - WAN Access 2 PPP Configuration
Issue 02 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
23
To Next Page
Loading...
Need help?
General
