Huawei Quidway S9300

path layer: B3 0
Last 600 seconds input rate 88 bits/sec, 0 packets/sec
Last 600 seconds output rate 32 bits/sec, 0 packets/sec
Input peak rate 15880 bits/sec,Record time: 2011-01-11 17:11:03
Output peak rate 1760 bits/sec,Record time: 2011-01-11 17:04:32
Input: 85 packets, 6781 bytes
Input error: 0 shortpacket, 0 longpacket, 2 CRC, 0 lostpacket
Output: 83 packets, 3872 bytes
Output error: 0 lostpacket
Input bandwidth utilization : 0.01%
Output bandwidth utilization : 0.01%
Run the ping command to check the network connectivity.
[SwitchA] ping 10.1.1.2
PING 10.1.1.2: 56 data bytes, press CTRL_C to break
Reply from 10.1.1.2: bytes=56 Sequence=1 ttl=255 time=3 ms
Reply from 10.1.1.2: bytes=56 Sequence=2 ttl=255 time=2 ms
Reply from 10.1.1.2: bytes=56 Sequence=3 ttl=255 time=2 ms
Reply from 10.1.1.2: bytes=56 Sequence=4 ttl=255 time=2 ms
Reply from 10.1.1.2: bytes=56 Sequence=5 ttl=255 time=2 ms
--- 10.1.1.2 ping statistics ---
5 packet(s) transmitted
5 packet(s) received
0.00% packet loss
round-trip min/avg/max = 2/2/3 ms
----End
Configuration Files
l Configuration file of Switch A
#
sysname SwitchA
#
interface Pos1/0/0
link-protocol hdlc
ip address 10.1.1.1 255.255.255.252
#
return
l Configuration file of Switch B
#
sysname SwitchB
#
interface Pos1/0/0
link-protocol hdlc
ip address 10.1.1.2 255.255.255.252
clock slave
#
return
Quidway S9300 Terabit Routing Switch
Configuration Guide - WAN Access 1 POS Interface Configuration
Issue 02 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
15