EasyManua.ls Logo

Huawei Quidway S9300

Huawei Quidway S9300
60 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Step 2 Configure Switch B.
# Add the user name of Switch A and the local password to the local user list of Switch B.
<Quidway> system-view
[Quidway] sysname SwitchB
[SwitchB] aaa
[SwitchB-aaa] local-user rta password simple hello
[SwitchB-aaa] quit
# Configure the IP address for POS 1/0/0 and configure the link-layer encapsulation protocol as
PPP.
[SwitchB] interface pos 1/0/0
[SwitchB-Pos1/0/0] ip address 10.110.0.2 255.255.255.0
[SwitchB-Pos1/0/0] link-protocol ppp
# Configure the peer to authenticate the local in CHAP mode.
[SwitchB-Pos1/0/0] ppp chap user rtb
Step 3 Verify the configuration.
After the configuration is complete, running the display interface command on every switch,
you can find the LCP state is LCP opened. Take the Switch A as the example.
[SwitchA] display interface pos 1/0/0
Pos1/0/0 current state : UP
Line protocol current state : UP
Last line protocol up time : 2011-01-11 17:35:02
Description:HUAWEI, Quidway Series, Pos1/0/0 Interface
Route Port,The Maximum Transmit Unit is 4470, Hold timer is 10(sec)
Internet Address is 10.110.0.1/24
Link layer protocol is PPP
LCP opened, IPCP opened
Physical layer is Packet Over SDH
Clock: Master, Scramble, Loopback: none, CRC: 32
Threshold: SD 10e-6, SF 10e-3
Flag: J0 "NetEngine "
Flag: J1 "NetEngine "
Flag: C2 0x16
SDH error:
section layer: B1 0
line layer: B2 0
path layer: B3 0
Last 600 seconds input rate 72 bits/sec, 0 packets/sec
Last 600 seconds output rate 64 bits/sec, 0 packets/sec
Input peak rate 4380776 bits/sec,Record time: 2011-01-11 17:34:39
Output peak rate 1760 bits/sec,Record time: 2011-01-11 17:04:32
Input: 11490 packets, 2495499 bytes
Input error: 185 shortpacket, 0 longpacket, 10618 CRC, 5 lostpacket
Output: 445 packets, 20044 bytes
Output error: 0 lostpacket
Input bandwidth utilization : 0.01%
Output bandwidth utilization : 0.01%
----End
Configuration Files
l Configuration file of Switch A
#
sysname SwitchA
Quidway S9300 Terabit Routing Switch
Configuration Guide - WAN Access 2 PPP Configuration
Issue 02 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
34

Table of Contents

Other manuals for Huawei Quidway S9300

Related product manuals