OPERATION
21
Problem The shading raises or lowers unevenly, the fabric rubs against one end of
the headrail, or the bottom rail is uneven when fully raised.
Solution Check that the window is square by measuring the diagonals.
Check that the installation brackets are level. Shim (not provided) to level,
ifnecessary.
Adjust the bottom rail weight (not applicable for LiteRise
®
shadings). See below.
LiteRise: Keep the bottom rail level while raising the shading. Side-to-side
movement while raising may cause the fabric to skew.
Adjust the Bottom Rail Weight (Front Shading)
■ Flip up the bottom rail to access the bottom rail weight.
■ To release the weight clip, insert a flat blade screwdriver into the weight clip
and turn clockwise.
■ Move the weight in 1" increments
toward the side where the fabric
isgathering.
■ Secure the weight clips in position by turning them counterclockwise after
making the adjustment.
■ Test and, if necessary, adjust again.
Adjust the Bottom Rail Weight (Rear Roller Shade)
■ Access the bottom rail weight from the back of the shade.
■ Push up on the weight clips to release them.
■ Move the weight in 1" increments toward the side where the fabric is
gathering.
■ Slide the weight clips back into place. Test and, if necessary, adjust again.
Weight
Clip
Clip
Fabric Roll
Move Weight
Weight
Weight
Push Up
Weight