Hunter Douglas Vignette - Remove The Shade

OPERATION
12
Attach the Magnetic Hold-Down Brackets (Optional)
■ Lower the shade until it is fully lowered and rotated
back toward the window.
■ Attach the magnetic hold-down brackets onto the
bottom rail just inside the end caps, oriented as
shown.
■ Mark the screw locations using one of the mounting
options shown below.
➤ The screw should be placed in the middle of the
channel. This will allow for adjustment.
■ Pre-drill the screw holes using a
3
/ 32 " drill bit.
■ Attach the hold-down brackets to the mounting surface using
the screws provided.
■ If necessary, adjust the bracket height by loosening the screw
and sliding the bracket up or down.
Outside Mount
Preferred Alternate
Inside Mount
Preferred Alternate
Adjust the
bracket
up or down
using the
channel.
Magnetic
Hold-Down
Bracket
End
Cap