Hunter Douglas Vignette - Attach The Hold-Down Brackets (Optional); Attach The Universal Cord Tensioner (UCT)

INSTALLATION
7
Mount the Installation Brackets — Outside Mount
■ Center the headrail over the window opening at the desired height. Use a pencil to lightly
mark each end of the headrail.
➤ Alternatively, measure the width of the headrail and use that width to mark the headrail
end points over the window opening.
■ Mark 3" from each end of the headrail.
➤ If more than two installation brackets came with your order, space additional bracket(s)
evenly between the two end brackets and mark their location. Mount into wood
whenever possible.
■ Two-On-One Headrail Shades. Place the installation brackets as shown in the
illustration below.
■ Center the brackets on your marks and mark each of the screwholes.
➤ A minimum 1" flat vertical surface is required.
➤ The top of the installation brackets should be at
the desired shade height. The brackets should be
level and aligned.
CAUTION: The rear of the brackets must be flush
against a flat mounting surface. Do not mount
brackets oncurved molding.
Window Opening
Space Evenly
Space Evenly3" 3"
Headrail End Mark Headrail End Mark
3"
Window Opening
Panel Split
Space Evenly
Space Evenly3"
3" 3" 3"
Headrail End Mark Headrail End Mark