14 hunter.direct/ACC2help
Basic Programming and Setup
PUMP/MASTER VALVE SETUP
In the decoder controller, P/MV outputs can be assigned to
either direct terminals in the controller, or to ICD-100 station
decoders.
P/MV outputs 1 through 3 refer to the output terminals on
the Power Supply Board, unless they are changed to decoder
locations. P/MV outputs 4, 5, and 6 must be assigned to
decoders.
All P/MV outputs are set to Normally Closed operation,
but they can be changed to Normally Open functions in
the Devices menu. See the P/MV Operation section
on page 20.
To Next Page
Loading...
