18 hunter.direct/ACC2help
Basic Programming and Setup
WATER DAYS
Verify you are in the correct program by number or name, and
set the days for automatic watering.
Mode selects a type of schedule.
• Day of Week: Check the boxes for the days the program
should water.
• Odd/Even: Water only on odd or even calendar dates,
to comply with water restrictions. An optional check box
allows skipping the 31st day of the month.
• Interval: Water every “x” number of days, regardless of the
day of week. Enter the desired interval days.
Both Odd/Even and Interval also have Non-Water Days, which
can set a day (for example, a mowing day) on which watering
will never occur, regardless of the schedule.
SEASONAL ADJUST
Programs menu, Seasonal Adjust.
When using Solar Sync, set up at Devices page rst, then go to
Seasonal Adjust.
• Seasonal Adjust Mode: Set a percentage adjustment to
all run times by Controller or Program, or set a Monthly
schedule for the controller to follow automatically, or
assign the program to Solar Sync automatic adjustment.
• Controller: The Seasonal Adjust value will follow whatever
has been set for the controller level. All programs set to
Controller will receive the same manual adjustment.
• Program: The Season Adjust factor entered here will only
apply to the selected program, and is not aected by other
adjustments.
• Monthly: Enter in advance the adjustment value for each
month of the year (usually based on historical weather
averages). These adjustments take eect automatically
on the 1st of each month, and do not change during the
month.
• Solar Sync: Adjustments are made to the selected program
automatically by a Solar Sync sensor attached to the
controller. This requires a sensor, and setup at the Devices
menu, Setup Solar Sync.
Each Program must have a Seasonal Adjustment set. Copy
and Paste shortcuts permit copying the initial setup, and then
pasting it to all similar programs.
To Next Page
Loading...
