Built on Innovation
®
25
Stations Menu
STATION LIMITS
Station Limits set how many stations can run at once, at
various levels.
Stack or Overlap means that each program can be manually
set to Overlap with other programs, or be required to stack.
Programs that are set to stack can only run by themselves.
SmartStack species a maximum number of programs that
are allowed to overlap across the whole controller.
Maximum Simultaneous Stations is the total number of
simultaneous stations that can occur for any reason in the
entire controller. This is mainly for use with the Flow Manager,
but applies to all situations.
If Flow Manager is enabled, the display will also show Program
Limits. This sets the max number of stations that can run
within any one program. This might be used to force irrigation
to be spread over a larger number of programs, when Flow
Manager is scheduling stations on to reach a ow rate target.
ACC2 Decoder can operate up to 30 simultaneous stations per
controller, but only 20 per decoder output module.
STATION SUMMARY
The Station Summary is a report available for each station
showing exactly how it is going to run, based on the current
setup and programming. It is a report only, and does not allow
changes to be made directly from this screen.
To Next Page
Loading...
