Hunter ACC2 - Important Connections and Tips; Connecting and Disconnecting the Facepack

Built on Innovation
®
5
Important Connections and Tips


CONNECTING AND DISCONNECTING THE FACEPACK
The facepack cable connection is located just below the light
on the Power Supply Board. Turn power to controller o
before connecting or disconnecting the facepack.
SYNCPORT™ CONNECTION
The SyncPort connection is a proprietary Hunter connection
for external interface devices. It is located near the top of the
Power Supply Module.

SyncPort

Facepack Cable Connection
Do not attempt to connect the facepack cable to
this port. The connector has a protective cover
that should be le in place until the connection
is needed.
If power to the controller is le o for extended
periods, the battery will be consumed more quickly.
Consult the connecting device’s manual for additional
instructions regarding SyncPort.
SD CARD READER
The bottom edge of the facepack includes a built-in SD card
reader. The controller is supplied with an SD card.
The SD card can:
• Upload updated rmware (saved from email or the
hunterindustries.com website) to the controller and all
its modules.
• Store logs, Easy Retrieve backups, and other information
for use later or on another device. See the Advanced
Features menu on page 32.
BATTERY
The facepack has a replaceable internal lithium battery in the
side of the facepack to back up date and time settings during
power outages (Program settings and other data are non-
volatile and do not require battery backup). The battery may
last the life of the controller, but is easily replaced if necessary.
Use a standard CR2032 replacement if necessary. Be sure to
place the + side of the battery correctly.