58 hunter.direct/ACC2help
Decoders Menu
FILTER
The Filter eld will normally show All decoders for the selected
output module. It can also be used to select New decoders
(found since the previous inventory), or Lost decoders (those
that are no longer responding since the previous inventory).
COMM %
This indicates how oen the decoder responded successfully
to the controller inventory. A low percentage rate may
indicate connection problems (poor waterproof connections,
shorts to earth ground, etc.). If the decoder responded with
a low success rate, it will probably still operate but may need
maintenance to prevent future issues.
UPDATE AVAILABLE
This indicates the status of each decoder’s rmware. The last
update of decoder rmware is stored in the decoder output
module’s memory.
If the decoder rmware is the same as that stored in the
decoder output module, the Update Available column should
show “No.” The decoder rmware is up to date.
When a decoder shows “Yes,” it means that there is newer
rmware in the decoder output module, and the decoder
should be updated (see Update Decoders).
EXPORT INVENTORY
The Export so key allows you to store the results of the
inventory on an SD card, if present in the controller facepack.
It will automatically suggest the day’s date as a le name, but
you may edit this if desired. Click Export to save the le for
future reference.
REFRESH INVENTORY
This starts a new inventory of all decoder output modules.
CLEAR INVENTORY
This so key completely removes the existing inventory.
UPDATE DECODERS
You can update all installed decoders via the two-wire paths
with this command, if a new version of decoder rmware is
available and uploaded into the controller.
Station and P/MV decoders are updated separately from
Sensor Decoders. Select the type of update to send, and press
the so key for update decoders.
Updating the decoders can take up to 20 minutes or more,
and automatic irrigation is not possible while the update is
running.
To Next Page
Loading...
