Operation Instructions for TCX50 Tire Charger
35
2.5 Tire Ination
• EXPLOSION HAZARD
• Never exceed tire pressure recommended by
tire manufacturer. Never mismatch tire size
and rim size.
• Avoid personal injury or death.
DANGER
Verify that both upper and lower tire beads and rim bead seat have been properly lubricated
with an approved mounting paste.
Do not lock the rim on the turntable during ination
Remove valve stem core if not already done.
Connect ination hose to valve stem.
Step down partially on the pedal to inate tire and seal beads with ination hose. Frequently
stop to check bead seating pressure on gauge.
Avoid personal injury. Follow the following instructions.
WARNING
1. Overinated tires can explode, producing hazardous ying debris that may result in an
accident.
2. Tires and Rims that are not the same diameter are “mismatched”. Never attempt to mount
or inate any tire and rim that are mismatched. For example, never mount a 16” tire on a
16,5” rim (or vice versa). This is very dangerous. A mismatched tire and rim could explode
and result in an accident.
3. Never exceed the Bead setting pressure (gauge on hose) provided by the tire
manufacturer stated on the sidewall of the tire.
4. Never place your head or any part of your body over a tire during ination process or when
attempting to seat beads. This machine is not intended to be a restraining device for
exploding tires, tubes or rims.
5. Always stand back from the tire changer when inating, never lean over.
To Next Page
Loading...
