Operation Instructions for TCX50 Tire Charger
26
Continue to press the wheel rotation pedal to rotate the wheel clockwise until the
entire bead is lifted from the rim.
Lift tire and repeat this procedure for lower bead.
Lift the mount/demount arm assembly up and away from the wheel.
Remove tire from rim.
For additional information on demounting special wheels, refer to “Advanced Demounting
Procedures,” page 41.
Leverless version
Using leverless mounting head follow always this indications
NOTICE
CHECK MOUNT HEAD
CALIBRATION MONTHLY
ALWAYS
LUBRICATE
TIRE
LUBE
1,5 mm
2 mm
Cod. 4-113552
ALWAYS MOUNT WITH BEAD
OVER BACK OF MOUNT HEAD
USE ASSIST FEATURES
TO PREVENT DAMAGE
Lockable arm
The leverless mounting head version is always equipped with lockable horizontal arm.
When the mounting head is not locked the horizontal arm is free to move.
Using the handle to lock the exagonal bar, the horizontal arm will be locked at the same time.
To Next Page
Loading...
