Hunter TCX50 - Using the Bead Press Head Hook to Lift the Tire; Mounting

Operation Instructions for TCX50 Tire Charger
51
Using the Bead Press Head Hook to Lift the Tire
Use the hook on the bead press head to help lift the tire during demount.
With upper bead demounted, use the bead lever and position the bead press head hook
under the upper bead on the opposite side of the tire.
Raise the bead press head hook.
Use lever to hook lower bead and pull over rim.
Remove the bead press head hook from the upper bead and complete removal of the lower
bead.
Mounting
Follow these steps:
1- Position the Bead Press Arm head near the mount/demount head. Lower it until the inner
bead is level with the drop center.