English-69
LUBRICATION
12. Parking Brake Cable
Remove the transmission cover, see "5. Gear lever” on
page 66.
Unhook the spring (A) from the screw (B) if required.
Remove the cable’s rubber casing when lubricating.
Lubricate the cable with an oil can, press the brake
pedal a few times and lubricate again.
Replace the spring (A) and the transmission cover.
13. Transmission oil level
1. Check the oil level in the transmission by looking
through the air intake mesh. The oil level shall be
between the MIN and MAX markings on the oil
container when at +20°C.
If the oil needs to be filled, you must first remove
the transmission cover.
2. Unscrew the oil container’s cover and fill with SAE
10W/30 engine oil, class SF-CC, until the oil level
reaches the “MAX” mark. Then screw the oil
container’s cap into place and attach the
transmission cover.
6020-005
B
A
6008-210
To Next Page
Loading...
